How to Set Up Coco Coir Grow Bags for Greenhouse Tomatoes
Set up one test row before the plants arrive. Check that the slabs fit the gutter, the drippers deliver evenly, and every bag drains.

The day before transplanting is a bad time to find out that the last few slabs in a row are still dry. If you’re trying a new bag size, blend or supplier, start with one row on the same gutter and irrigation zone you’ll use for the crop. Record what worked so the crew can repeat it across the house. For bag formats, EC targets and supply options, see our overview of coco coir for greenhouse tomatoes.
1. Check the fit with a fully expanded slab
Set the bags in the gutter before you wet them. Make sure the planting holes line up with your spacing and that the drip lines reach the blocks without pulling. Once a trial bag expands, check the fit again. If the film is pinched against the gutter wall or a drain opening sits over a support, sort it out before laying the rest of the row. If you’re changing formats, use Avee’s grow slab specification checklist to compare expanded dimensions, hole layout and film.
2. Catch the output from several drippers
Place identical cups under drippers near the inlet, midway down the line and at the far end. Run the same irrigation shot into all the cups and compare the volumes. If one is low, check for a kink, blockage or loose connection and repeat the test. If a whole stretch is low, check the line pressure and filter before changing the timer.
3. Hydrate a few bags and check the middle
Follow the bag supplier’s instructions for hydration and the timing and placement of drain openings. Check the ends and middle of a few test bags after expansion. If the surface looks wet but a test slab still has a firm, dry core, check emitter placement and allow time for the water to spread before repeating the hydration step. Use a spare slab for any check that requires opening the film. UF/IFAS guidance on greenhouse soilless media explains how compressed coir bags are expanded and drained before use.
4. Watch where the water goes
Once the bags are prepared, run a test shot and watch the drain openings and the gutter outlet. A bag that stays pooled while its neighbours drain is a reason to check that bag’s outlet and position. If several bags back up together, check the gutter slope and outlet. Write down the shot length, catch volumes, where you sampled, and any adjustments before repeating the setup on the next row.
Before you bring in the transplants
Walk the row once more with the crew. Check that the bags are evenly expanded, the blocks will sit flat on the coir, and each dripper reaches its planting position. Keep the setup notes for the next delivery. After planting, use the coir irrigation guide for monitoring runoff, EC and dryback as the crop establishes.